6
English
▶
Do not use the magazine as a grip.
▶
Do not use the tool in places where there is a risk of fire or explosion unless the tool
is specially approved for this type of use.
▶
Never drive fasteners into existing holes unless this is recommended by
Hilti
(e.g.
DX-Kwik).
Workstation
▶
Keep the workplace tidy. Objects which could cause injury should be removed from
the working area.
◁
Untidiness in the working area can lead to accidents.
▶
Make sure that the working area is well lit and well ventilated.
Mechanical safety rules
▶
Do not tamper with or modify the tool or parts of it, especially the piston.
▶
Use only fasteners of a type approved for use with the tool.
Thermal safety rules
▶
Do not exceed the recommended maximum fastener driving rate.
▶
If the tool has overheated, allow it to cool down.
▶
Do not dismantle the tool while it is hot. Allow the tool to cool down.
2.4 Careful handling and use of batteries
▶
Observe the special guidelines applicable to the transport, storage and use of lithium-
ion batteries.
▶
Do not expose batteries to high temperatures, direct sunlight or fire.
▶
Do not take apart, squash or incinerate batteries and do not subject them to
temperatures over 80 °C.
▶
Do not attempt to charge or continue to use damaged batteries.
▶
If the battery is too hot to touch, it may be defective. In this case, place the power
tool in a non-flammable location, well away from flammable materials, where it can be
kept under observation and left to cool down. Contact
Hilti
Service after the battery
has cooled down.
Printed: 04.10.2017 | Doc-Nr: PUB / 5377202 / 000 / 01
Summary of Contents for BX 3-ME
Page 1: ...BX 3 ME English Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
Page 2: ...Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
Page 9: ...English 7 3 Description 3 1 Product overview Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
Page 23: ...Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
