32
English
2330315
*2330315*
4.4
Vibration information, measured in accordance with EN 60335-2-69
Vibration emission value
< 2.5 m/s²
Uncertainty (K)
Is taken into account in
the stated value
5
Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶
Before inserting the battery, make sure that the product is switched off.
▶
Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1
Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 25
5.2
Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶
Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶
Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3
Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4
Changing the dust bag
1. Set the control switch to the
OFF
position.
2. Open the 2 latches.
3. Lift the suction head off the waste material container.
4. Remove the dust bag.
▶
Dispose of the dust bag in accordance with the applicable regulations.
5. Secure the holder with the dust bag to the ribs of the waste material container.
6. Fit the suction head on to the waste material container and close the 2 catches.
5.5
Connecting/disconnecting the suction hose
1. To connect, push the suction hose into the intake fitting.
2. To disconnect, twist the suction hose back and forth and pull it out of the intake fitting.
5.6
Setting the hose diameter
1. For vacuuming up dry, non-flammable dust which has an exposure limit value, or when vacuuming up
wood shavings, adjust the hose diameter setting switch to the correct diameter setting for the suction
hose used.
2. Change the setting for the hose diameter, and consequently the threshold for the acoustic warning, by
repeatedly pressing the
button.
Summary of Contents for NURON VC 10H-22
