36
English
2330315
*2330315*
3. Lift the suction head off the waste material container, turn the suction head upside down and lay it aside.
4. Turn the filter latches through 180 °.
5. Remove the filter frame with filter.
▶
Make sure that no foreign matter drops into the turbine aperture!
6. Remove all dust from the seal and from the filter frame holder.
7. Set the filter frame on a new filter.
8. Fit the filter frame complete with filter into the holder for the filter frame.
9. Lock the filter frame into position with the filter latches.
10. Fit the suction head on to the waste material container and close the two catches.
11. If applicable, remove dust that has dropped from the filter element or the vacuum cleaner.
7.4
Checking the container level monitoring system
1. Set the control switch to the
OFF
position.
2. Open the 2 catches.
3. Lift the suction head off the waste material container,
turn the suction head upside down and lay it aside.
▶
Allow the filter element to dry.
4. Check cut-off contacts (wire sensors)
(A)
and
(B)
for
dirt accretions and if necessary, brush the contacts
clean with a soft brush.
5. Check the seal at the vacuum cleaner top section
and clean it with a cloth if necessary.
6. Position the vacuum cleaner top section on top of
the waste material container.
7. Close the two catches.
8. Check to ensure that the suction head is fitted cor-
rectly and secured.
8
Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport
!
▶
Always transport your products with the batteries removed!
▶
Remove the battery/batteries.
▶
Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit.
Comply with the locally applicable
regulations for transporting batteries.
▶
Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶
Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries
!
▶
Always store your products with the batteries removed!
▶
Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶
Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶
Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶
Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
Summary of Contents for NURON VC 10H-22
