English
9
1. Fig. 1: Working in horizontal mode.
2. Fig. 2: In inclined plane mode, the laser should be lifted at the control panel side.
3. Fig. 3: Laying down or transporting in an inclined position.
◁
Hold the laser so that the battery compartment does NOT face upwards, so that no moisture can
enter.
5.2 Inserting / removing the battery
CAUTION
Electrical hazard.
Dirty contacts may cause a short circuit.
▶
Check that the contacts on the battery and on the tool are free from foreign objects before inserting
the battery.
CAUTION
Risk of injury.
If the battery is not fitted correctly it may drop out and fall.
▶
Check that the battery is securely seated in the tool so that it cannot drop out and fall, thereby
presenting a hazard to other persons.
1. Push the battery in until it engages securely.
◁
The laser is ready to switch on.
2. Press the release button and hold it in this position.
3. Pull the battery out.
5.3 Switching the laser on and working in the horizontal plane
Note
Check the accuracy of the laser tool before using it for important tasks, especially if it has been
dropped or subjected to unusual influences or impacts etc.
Printed: 31.07.2017 | Doc-Nr: PUB / 5260662 / 000 / 01