>1/4s
620-690nm/2.45mW max.
CLASS IIIa LASER PRODUCT
LASER RADIATION - DO NOT
STARE INTO BEAM
C A U T I O N
3R
LASER RADIATION - DO NOT
STARE INTO BEAM
675-695nm / 2.5mW max.
CLASS IIIa LASER PRODUCT
C A U T I O N
3R
PRE 38
Power:
6.0V=nom./200 mA
3R
N13813
01
Hilti=trademark of Hilti Corp., Schaan, LI Made in Japan
LASER RADIATION - DO NOT
STARE INTO BEAM
675-695nm / 2.5mW max.
CLASS IIIa LASER PRODUCT
CAU T I O N
Item no.: 419352
Date: XX.XXXX
419355
EN 60825-1:2007 FCC ID:
1 General information
1.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
NOTE
Draws attention to an instruction or other useful informa-
tion.
1.2 Explanation of the pictograms and other
information
Symbols
Read the
operating
instructions
before use.
General
warning
Return waste
material for
recycling.
Do not look
into the
beam.
Symbol for Laser Class III / Class 3
Laser Class IIIa
according to
CFR 21, § 1040 (FDA)
Do not look
into the beam
with the naked
eye or with
optical
instruments.
On the tool
Do not stare into the beam.
Laser warning plates for the USA according to CFR 21 §
1040 (FDA).
On the tool
Laser warning plate according to IEC825 / EN60825-
1:2007
Type identification plate
PRE 38
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:
2 Description
2.1 Use of the product as directed
The Hilti PRE 38 is a grade laser that projects a rotating laser beam.
The tool is designed to be used for determining, transferring and checking references in the horizontal and inclined
planes. Examples of uses are the transferring of datums and heights.
Use of tools or AC adapters which show visible signs of damage is not permissible.
Operation outdoors or in damp conditions in “charging during operation” mode is not permissible.
Hilti supplies various accessories which allow the tool to be used with maximum efficiency.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
en
18
Printed: 08.07.2013 | Doc-Nr: PUB / 5070345 / 000 / 01
