*2264219*
2264219
English
13
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
10
Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed
Status indicators of the Liion battery
.
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact
Hilti
Service.
Trouble or fault
Possible cause
Action to be taken
The saw blade drops out.
The saw blade is not correctly en-
gaged.
▶
Repeat the insertion procedure.
▶
Make sure that the blade holder
is fully open and that the saw
blade is pushed all the way in
against the spring resistance.
The clamping system is clogged
with foreign matter.
▶
Clean out the blade holder.
The saw blade cannot be
inserted.
The clamping system is clogged
with foreign matter.
▶
Clean out the blade holder.
The orbital action cannot be
adjusted.
Foreign matter in the orbital-action
adjusting lever groove.
▶
Clean out the orbital-action
adjusting lever groove.
The orbital action doesn’t
work.
The orbital-action mechanism is
clogged with foreign matter.
▶
Check whether foreign matter
is present in the area of the
orbital-action fork and clean it
out.
The orbital-action adjusting lever is
in position “0”.
▶
Adjust it to the desired setting.
The battery runs down more
quickly than usual.
Very low ambient temperature.
▶
Allow the battery to warm up
slowly to room temperature.
The battery does not engage
with an audible click.
The retaining lug on the battery is
dirty.
▶
Clean the retaining lug and
re-insert the battery.
The power tool or battery
gets very hot.
Electrical fault
▶
Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact
Hilti
Service.
LEDs of the battery show
nothing
Battery defective
▶
Contact
Hilti
Service.
11
Disposal
WARNING
Risk of injury due to incorrect disposal!
Health hazards due to escaping gases or liquids.
▶
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your
Hilti Store
, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which
Hilti
products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to
Hilti
for recycling. Ask
Hilti
Service or your Hilti sales representative for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
Summary of Contents for SJT 6-22
