20
en
-CAUTION-
●
When working with the tool, always guide it away from
the body.
●
Lift the tool away from the workpiece only after the
blade has come to a standstill.
●
Lay the tool down only after the blade has come to a
standstill.
-CAUTION-
●
The saw blade becomes hot during
long periods of use.
●
There is a risk of burning if the blade
is touched.
●
Wear protective gloves.
7.2 Switching on / off
7.2.1 On / off switch (WSJ 750-ET /
WSJ 850-ET)
1. Plug the supply cord into the electric socket.
2. Switch the tool on by pressing the on / off switch.
– Switching on: Press the on / off switch.
– Switching off: Release the on / off switch.
– Sustained
operation:
Press the on / off switch and then
press the switch lockbutton.
– Switching off: Press the on / off switch again and
then release it.
7.2.2 On / off switch (WSJ 750-EB /
WSJ 850-EB)
1. Plug the supply cord into the electric socket.
2. Switch the tool on / off by way of the sliding switch.
7.3 Plunge sawing
-NOTE-
Use the plunge sawing method only for soft materials.
Only short blades should be used.
1. Plug the supply cord into the electric socket.
2. Set the orbital action regulation lever to the 0 posi-
tion.
3. Bring the front edge of the baseplate into contact with
the workpiece.
6.11 Anti-splinter insert
-NOTE-
The anti-splinter insert cannot be used with certain types
of saw blades (e.g. offset blades).
Use of the anti-splinter insert helps prevent splintering
of the surface when sawing wood materials.
1. Unplug the supply cord from the electric socket.
2. Press the anti-splinter insert into the baseplate from
below.
6.12 Low-friction baseplate cover
-NOTE-
Use the low-friction baseplate cover to avoid scratching
sensitive materials.
1. Unplug the supply cord from the electric socket.
2. Hook the cover onto the front edge of the baseplate.
3. Press the cover against the baseplate until it snaps into
place.
7. Operation
-CAUTION-
●
The cutting edges of the saw blade
are sharp.
●
The cutting edges may present a risk
of injury.
●
Wear protective gloves.
-CAUTION-
●
The sawing operation swirls up dust
and wood chips into the air.
●
The dust and wood chips may be harm-
ful to the eyes and respiratory system.
●
Wear protective goggles and breath-
ing protection.
-CAUTION-
●
Operation of the tool creates noise.
●
Excessive noise may damage the
hearing.
●
Wear ear protection.
7.1 System
-NOTE-
●
To achieve good cutting performance and ease the
load on the tool, always use blades that are in good
condition.
●
Do not overload the tool.
Printed: 07.07.2013 | Doc-Nr: PUB / 5138188 / 000 / 00
