security
security
30
3.2.20
Devices (CONNECTORS)
Devices connected on the bus 485 must be enabled to allow for operating on the central unit.
Select the option :
And press or
With buttons to select device to enable o desable and press or
To modificate the configuration .
For example by selecting :
(Upper on the right appear physical ID on the network RS485 )
Dial and the display shows:
If enable a device not connected on the central unit the display signale:
Devices that’s possible to activate on the bus 485 are:
- Console
- with addresse 8.
- Connector 1 , 2, 3 e 4
- with addresses 16,17,18 e 19.
- Radio 1 and 2 (DXR2/DXR1)
- with addresses 32 e 33.
- Module Link
- with addresse 1.
Note: every missed connection on an enabled device on the bus 485 is indicated on the display through a
message during the visualization of the status of the central unit, also when it doesn't generate an alarm
24h.
D e v i c e s 4 8 5
K e y r e a d e r 1 1 6
D i s a b l e d
K e y r e a d e r 1 1 6
E n a b l e d
K e y r e a d e r 1 1 6
L i n k B A D
Programming
31
XR400GSM
- XR
800GSM - Installation guide and use
3.2.21
Connectors Activation
Devices connected on bus 485 must be configured to allow the manage on the central unit.
To select the option :
And press or
With bottons to select the device to enable or disable and press or to modify the
configuration.
For example by selecting :
(Upper on the right appear physical ID on the network RS485 )
Dial and the display shows:
If enable a device not connected on the central unit the display signale:
When a device on bus 485 to manage generate an alarm 24h for failure connection (when enabled) on
display appear the indication:
Or if the device dispositivo in the meantime starts to engage with the central unit :
Devices that can be attivare sul bus485 are:
- Consolle
- with addresse 8.
- Connector 1 , 2, 3 e 4
- with addresses 16,17,18 e 19.
- Radio 1 and 2 (DXR2/DXR1)
- with addresses 32 e 33.
- Module Link
- with addresse 1.
Notes: every missed connection on an enabled device on the bus 485 is indicated on the display through
a message during the visualization of the status of the central unit, also when it doesn't generate an alarm
24h.
To enable the connector 2 or next, to repeat the operation from the beginning of the page.
C o n n e c t o r 1 1 6
N O T A C T I V E
C o n n e c t o r 1 1 6
L I N K O K
C o n n e c t o r 1 1 6
L I N K B A D
C o n s o l l e 8
L i n k B A D
C o n n e c t o r 1 1 6
L I N K B A D M e m . 2 4 H
C o n s o l l e 8
L i n k O K M e m 2 4 H