System
Product Description
HI 803 211 E Rev. 1.01.00
Page 63 of 110
4.13
Communication
Communication with other HIMA systems or third-party systems occurs via communication
modules. HIQuad X supports the following communication protocols:
safe
ethernet
(safety-related).
Standard protocols.
For details on communications and supported standard protocols, refer to the communication
manual (HI 801 101 E).
4.13.1
Licensing
Standard protocols can only be run in the long term with a valid license. For some protocols, a
software activation code is required. For activation, see Chapter 4.15.
i
Order a software activation code on time!
After 5000 operating hours, communication continues until the controller is stopped.
Afterwards, the user program cannot be started without a valid software activation code for the
protocols used in the project (invalid configuration).
4.14
Connecting the PADT to the System
The physical connection between the PADT and a HIQuad X system is established by
connecting the Ethernet interface of a PC to an RJ-45 socket (X1, X2) of a processor module. A
PADT (programming and debugging tool) is a personal computer (PC) that is running the
SILworX programming tool.
The connection requires a patch cable that complies with Cat. 5e or better and is connected to a
free PC network card.
A HIQuad X system can simultaneously communicate with up to 5 PADTs. If this is the case,
only one programming tool can access the controller with write permission. The remaining
PADTs can only read information. If they try to establish a writing connection, the controller only
allows them a read-only access.
Summary of Contents for HIQuad H41X
Page 1: ...Manual HIQuad X System Manual...
Page 109: ......