Fig. 1
INSTALLATION
NOTE:
This remote control unit is equipped with 16 code
combinations to prevent possible interference from or to other
remote units. The frequency switches on your receiver and
transmitter have been preset at the factory. Please recheck to
make sure the switches on transmitter and receiver are set to the
same position, any combination of settings will operate the fan
as long as the transmitter and receiver are set to the same
position.
Remove the set screw on the back of transmitter, take out the
battery cover. Insert the 3 volt battery (included) and make sure
they are seated correctly in each recess with the Po sign
facing up. When remove or insert the batteries, use a suitable
screwdriver to loosen or tighten the screws and open the back
cover. (Fig. 1)
NOTE:
To prevent damage to the transmitter, remove these
batteries if not used for long periods of time (months).
WARNING:
Chemical Burn Hazard. Keep batteries away from
children.
This product contains a lithium button/coin cell battery. If a new
or used lithium button/coin cell battery is swallowed or enters
the body, it can cause severe internal burns and can lead to death
in as little as 2 hours. Always completely secure the battery
compartment. If the battery compartment does not close
securely, stop using the product, remove the batteries, and keep
it away from children. IF you think batteries might have been
swallowed or placed inside any part of the body, seek immediate
medical attention.
The batteries shall be disposed of properly, including keeping
them away from children; Even used cells may cause injury.
SETTING THE CODE
This unit has 16 different code combinations. To set the code,
perform these steps:
A.
Setting the code on the transmitter:
Slide the code switches to your choice of up or down
position. (Factory setting is all up). Do not use this
Position. Use a small screwdriver or a ballpoint pen to slide
firmly up or down (Figure 1).
B.
Setting the code on the receiver:
Slide the code switches to the same positions as set on your
transmitter (Figure 1).
Set screw
Frequency switches
Transmitter
ON
ON
ON
Receiver
3 SPEED FAN & LIGHT
REMOTE CONTROL
INSTALLATION INSTRUCTIONS
Model: 980005
READ AND SAVE THESE INSTRUCTIONS
For use with AC fans only
