Hinkley SAWYER 36, Instruction Manual

OPERATION

Your DC brushless motor is equipped with an 

automatically learned type remote control. 

There is no frequency switches on the receiver 

or transmitter. The fan can start to use once the 

pairing process is done.

Remove the panel from the transmitter and then 

install one 2032 battery (included). You need to 

use a coin to open or close the battery cover.  

To prevent damage to transmitter, remove the 

battery if not use for long periods of time (Fig. 1)

Fig. 1

Fig. 2

Signal light

ON

OFF

1

2

3

4

5

             button:

         Press this button and release instantly to 

         turn on or off the light.

                 button:

         Press and hold to dim or brighten lights  

         to the desired level and release.

                button:

         Press this button to set fan wind direction 

         up or down.

                 button:

         Press button for turn on and setting 1-6 

         fan speed.

               button:

         Press this button to turn the fan off. 

         Signal light (Fig. 2)           

6

WARNING: 

Chemical Burn Hazard. Keep 

          batteries away from children.

This product contains a lithium button/coin cell 

battery. If a new or used lithium button/coin cell 

battery is swallowed or enters the body, it can 

cause severe internal burns and can lead to 

death in as little as 2 hours. Always completely 

secure the battery compartment. If the battery 

compartment does not close securely, stop 

using the product, remove the batteries, and 

keep it away from children. IF you think 

batteries might have been swallowed or placed 

inside any part of the body, seek immediate 

medical attention.

The batteries shall be disposed of properly, 

including keeping them away from children; 

Even used cells may cause injury.

HIRO Control System

©2020 Hinkley Lighting, Inc. 

|

 hinkley.com 

|

13

Pairing Process

NOTE: If installing/pairing more than 
one fan in an area, the power must be 
disconnected from all fans except the one 
fan being paired. 

With the fan’s power off, restore power to the

fan. Press and hold “      ” button for about 5

seconds and release. If optional light kit is

installed, the light kit will flash three times and 

the motor spin up for 10 seconds on low speed. 

The fan has completed the pairing process with 

the wall control and is ready for use.

NOTE:

 A single fan can be controlled with as

many as 3 wall controls in one room. Every

control will need to repeat the pairing process

based on instructions above and all controls

must be within 30 feet of the fan.