HYBRID/TROUBLE SHOOTING
3–130
INSPECTION PROCEDURE: P0A0F (TC31)
1.
Set the starter key to the "LOCK" position.
2.
Connect the diagnosis tool (HINO-DX) to the vehicle.
3.
Set the starter key to the "ON" position.
4.
In [Fault Information] on the diagnosis tool screen, check if any
engine system DTC is detected.
NO
YES
1.
Check the fuel meter (in the combination meter) to make sure that
the fuel level is Lo level or above.
NO
YES
1
Inspecting the engine ECU [HINO-DX]
SHTS03ZZZ0300089
Is any DTC detected from the engine ECU?
Perform troubleshooting for each DTC of
engine ECU.
Go to step 2.
2
Inspecting the fuel level
Is the fuel level at Lo level or above?
Go to step 3.
Fill the fuel and go to step 3.
