HYBRID/TROUBLE SHOOTING
3–179
INSPECTION PROCEDURE: P0A85 (TC65)
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the PCU harness (16P) connector and the HV ECU2
connector.
3.
For the 11th terminal of PCU harness (16P) lower-side connector,
inspect the signal line of PCU wire harness (lower side) for short
circuit. (See "Inspecting the PCU harness signal line for short cir-
cuit.")
NO
YES
1
Inspecting the signal line of PCU wire harness (lower side) for short circuit
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
PCU harness (16P)
lower-side con-
nector
11th terminal
–
Each signal line
10 k
or more
Is any defect found?
Replace the PCU wire harness (lower side).
Go to step 2.