To the engine start by low temperatures do never use additives such as
gasoline, ether for paints, gases or other volatile fluids, as they would
seriously damage the engine.
Keep always the rubber cap closed except when you have to pour in oil. In
fact, when the cap is not on, some impurities, rain or other contaminating
substances could enter the motor and cause its quick wear.
4.4.1.2 ELECTRICAL START
1. Engine start
(all preparations for the electrical start are exactly the same as for the manual start)
a)
Open the fuel cock;
b)
Position the acceleration lever to “START”;
c)
Turn the engine start key to the position “START”;
d)
Leave the key as soon as the engine has started;
e)
If the engine does not start after 10 seconds, wait a little bit (15 seconds
roughly) before trying again.
If the starting motor remains switched on too long, the battery gets
unloaded and the starter itself can block. While translation movement
keep always the key on position “ON”.
1. Battery
Check at least monthly the electrolyte level.
When the minimum level is reached then
pour in distilled water up to maximum level.
If the electrolyte level is too low, the
engine cannot start. Keep always the
electrolyte level between maximum and
minimum limit.
By a too high level the electrolyte can go
out and corrode any adjacent part.
M
M
M
M
A
A
A
A
N
N
N
N
U
U
U
U
A
A
A
A
L
L
L
L
U
U
U
U
S
S
S
S
E
E
E
E
A
A
A
A
N
N
N
N
D
D
D
D
M
M
M
M
A
A
A
A
II
II
N
N
N
N
T
T
T
T
E
E
E
E
N
N
N
N
A
A
A
A
N
N
N
N
C
C
C
C
E
E
E
E
M
INIDUMPER MODEL
HP 1100
22
IMPORTANTE
ATTENZIONE
ATTENZIONE
1.MAXIMUM LEVEL 2.MINIMUM LEVEL
ATTENZIONE
CAUTION
CAUTION
CAUTION
IMPORTANT
