M
M
M
M
A
A
A
A
N
N
N
N
U
U
U
U
A
A
A
A
L
L
L
L
U
U
U
U
S
S
S
S
E
E
E
E
A
A
A
A
N
N
N
N
D
D
D
D
M
M
M
M
A
A
A
A
II
II
N
N
N
N
T
T
T
T
E
E
E
E
N
N
N
N
A
A
A
A
N
N
N
N
C
C
C
C
E
E
E
E
M
INIDUMPER MODEL
HP 1100
32
the slant of the ramp does not exceed 15°.
2. Loading platforms must be strong and wide enough and have the right slant for
the machine to go over them.
3. Before loading the machine, clean thoroughly the ramp and the flatbed. Oily,
muddy, icy ramps or flat beds can be slippery.
Warning: During cold weather, give the machine time to warm up before
loading or unloading it.
Warning:
1. Avoid steering when going up or down ramps, as it is extremely
dangerous. If absolutely necessary, first reverse to the ground or onto the
flatbed. Then change directions and start driving again.
2. Never operate any other levers but the drive lever when going up or down
a ramp. Otherwise the machine might get unbalanced.
3. There is a bump up the ramp. Take care when crossing it.
4. Always drive slowly on a ramp.
5. The machine mid line must always be on the trailer mid-line.
Important: Always fasten chains and cables to the machine frame. Never put
chains or cables on or against hydraulic tubes.
6. Put blocks in front and behind the tracks.
7. Fasten every machine corner and the front tool to the trailer with a chain or a
cable equipped with a suitable load fastener.
During transport, turn fuel valve on OFF and make sure the engine stays flat to
avoid any fuel leaks.
Petrol fumes or oil leaks could take fire.
P
RECAUTIONS WHEN TRANSPORTING A MACHINE WITH RUBBER TRACKS
When transporting a machine with rubber tracks, always secure the right and left
tracks onto the lorry flatbed by means of metal cables and soft guards.
The metal cables must never touch the rubber tracks.
INCLINAZIONE INFERIORE A 15
°
SLOPE LESS THAN 15°
