5.3.1 HYDRAULIC OIL
Checking hydraulic oil
To check oil level, place the machine flat and check
that the oil level is about half the inspection hole A.
If not, top up through the filling cap B.
Changing hydraulic oil
For a complete hydraulic oil change, do the
following:
- open top up cap B;
- loosen drain plug C at the bottom part of the tank;
- drain completely the oil contained in the tank.
Clean the tank thoroughly before filling.
Tighten drain plug C and fill the tank through the
filler cap B avoiding mixing different oils.
Only use mineral based oil with wearproof agent HLP type (DIN 51524) or HM (ISO
6743/4) with a viscosity according to ISO VG46 regulations. The recommended
filtration must be absolute 10 m or b 10
≥
75.
5.3.2 HYDRAULIC OIL FILTER
Replacing hydraulic oil filter
The hydraulic oil filter is situated in the upper part of
the hydraulic oil tank. To reach it, loosen screws on
the filter cover and replace cartridge A.
M
M
M
M
A
A
A
A
N
N
N
N
U
U
U
U
A
A
A
A
L
L
L
L
U
U
U
U
S
S
S
S
E
E
E
E
A
A
A
A
N
N
N
N
D
D
D
D
M
M
M
M
A
A
A
A
II
II
N
N
N
N
T
T
T
T
E
E
E
E
N
N
N
N
A
A
A
A
N
N
N
N
C
C
C
C
E
E
E
E
M
INIDUMPER MODEL
HP 1100
36
B
A
A
C
