31
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
A
A
N
N
D
D
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
M
M
A
A
N
N
U
U
A
A
L
L
TP2000
4.3.2.6 T
OWING THE MACHINE
The machine must not be towed.
Any attempt to tow the forklift may damage the transmission.
4.3.2.7 T
RANSPORTING THE MACHINE
L
OADING THE MACHINE ON A TRUCK WITH LOW BED
.
Always load and unload the machine on a firm and level surface.
Warning: remember to use a ramp or a loading platform to load/unload the
machine.
1
. The ramps must be strong enough to support the weight of the machine. Make
sure that the gradient of the ramp is less than 20°.
2
. The ramps must be wide and strong enough and must have a suitable slope for
the machine to drive on.
3
. Before loading the machine, fully clean the ramp and the platform. Ramps or
platforms that are dirty with oil, mud or ice are slippery and dangerous.
W
ARNING
: during colder periods let the machine warm up before loading/unloa‑
ding it.
A
TTENTION
:
1
.
Avoid steering when driving up or down a ramp, as this is extremely dange‑
rous. If steering is unavoidable, first return to the ground or the low loading
platform, then change direction and start driving again.
2
.
Do not operate any lever other than the gear levers when driving up or down
a ramp to prevent the machine from losing balance.
3
.
At the top end of the ramp, when the forklift reaches the bed of the truck, the
gradient changes. Take care when driving over this section.
4
. Drive the machine slowly on the ramp.
IMPORTANTE
INCLINAZIONE INFERIORE A 15°
GRADIENT BELOW 20°
IMPORTANT
Summary of Contents for TP2000
Page 12: ...Generelt 52220012 12 35 NO ...
Page 69: ......
