12
STEP 2.
Attaching Ratchet Wheels to Poles
Slide the ratchet wheel onto the end of the
conduit. The wheel should be flush with the
end of the conduit. If the edges of the con-
duit are a little rough you will want to file
them smooth for easier assembly. Tighten
the hex head bolt using the hex head
wrench provided.
See Fig. 2.
Just snug it
up so the bolt assembly doesn’t fall out.
Repeat steps 1 and 2 to attach ratchet
wheels loosely to the ends of 3 of the con-
duit rollers.
STEP 1.
Assembling Ratchet Wheels
The 3 ratchet wheels will be attached to
the right end of 3 of the conduit rollers.
Using the hardware found in the ‘roller
end hardware’ bag, slip the 1/4” washer
onto the hex head bolt and then screw
the hex head bolt into the barrel nut only
about 3 or 4 turns. Lay the bolt assem-
bly into the pocket in the ratchet wheel.
See Fig 1.
The bolt assembly must lay
flat inside the pocket or it could rub
against the inside of the end frame.
FIG. 2
FIG. 1
WASHER
STEP 3.
Tightening the Roller Ends
Tighten all three ratchet wheels onto the
conduit.
See Fig. 3.
FIG. 3
RATCHET WHEEL ASSEMBLY INSTRUCTIONS
Locate bag of hardware labeled “Roller End Hardware”
