54
4.3 Measuring Current
Output Settings
If you don’t need to make any output settings, proceed to "Auto
Zero Adjustment (for DC and AC+DC modes)" (page 57).
3.
Confirm that the optional 9094 OUTPUT CORD is inserted
securely into output jack 1 (OUT1)
(OUT2 is for integral value out-
put)
.
4.
Press
SHIFT
→
(
OUTPUT
) to display the output settings.
5.
Set OUT1 to REC or MON.
Only REC output is available at OUT2.
MON
MON (Monitor) Output
Outputs the measured waveform (settable for all mea-
surement modes).
REC
REC (Record) Output
The measured waveform is converted from rms (RMS/
DC conversion) for output (settable for AC and AC+DC
modes).
The response speed can be changed by pressing
SHIFT
→
(
SAMPLE
).
• Be sure to select the measurement range before making out-
put settings. If you make output settings with AUTO ranging
selected, the range that is active at setting time becomes the
fixed range (the L range if nothing is being measured).
• In the DC mode, INTEG OUTPUT (bar graph display) switches
between ±, + and -. Integral output can be set with current
measurement output settings.
For AC and AC+DC modes there is no ±, + or - selection.
• Auto power-off is disabled (
not displayed) when making
output settings. Output settings do not affect battery consump-
tion.
Summary of Contents for 3290-10
