7
_____________________________________________________________________
Chapter 2Set Up
______________________________________________________________
During recording
(Power Save function set to ON)
Recording-Interval
Setup Screen
2.2 Power Save Function
If no recording session is under way, the screen display is
automatically turned off approximately 15 seconds after the
last key entry (Sleep). However, the recording-interval setup
screen will not enter the Sleep state, even in the absence of
key operation.
The Power Save function mode is set to ON in the initial
settings. If the Power Save function is disabled, the battery
service life will be approximately 15 days. For the setting
procedure for the Power Save function, refer to the "3911-
20 COMMUNICATION BASE Instruction Manual" and the
Measurement Guide.
When the Power Save function is set to ON (enabled)
before measurement starts, the measurement-value display
turns off 15 seconds after measurement starts, and the unit
automatically enters the Power Save function. To turn on
the measurement-value display again, press any key. The
measurement-value display turns on, then turns off after 15
seconds, and the unit automatically enters the Power Save
function again.
When the Power Save function is set to OFF (disabled)
before measurement starts, pressing the INTERVAL button
turns the Power Save function ON/OFF. When the
measurement-value display is on, the Power Save function
is set to OFF. When the measurement-value display is off,
the Power Save function is set to ON. For an extended
measurement operation, set the Power Save function to ON
(measurement-value display turned off).