3.3 Making Settings from the LR5000 Utility Program
37
3
3
Chapter 3 Set
tings
1. Set the following options.
2. Confirm settings.
3. Click the
[Save]
button.
(Scaling settings are saved, and the display returns to the Logger Settings screen.)
Note: If you click the
[Cancel]
button without saving the settings, the display still returns to
the Logger Settings screen.
Alarm Thresholds (set as needed)
Set the upper and lower alarm threshold values.When a measurement is outside of
the specified area, the
[AL]
(alarm) indicator is displayed on the logger.
Click the
[Save]
button to save your settings.
(The display returns to the Logger Settings screen.)
Note: If you click the
[Cancel]
button without saving the settings, the display still returns to the
Logger Settings screen.
Note: Alarm judgment is performed at every recording interval during instantaneous recording,
and once per second during statistical recording.
Note: Alarm judgment is performed using measurement values with a larger number of digits
than the values (4 digits) indicated in the LR5011 display.
Note: The
[AL]
indicator appears when the measured value is out of range (OF/UF dis-
played), and when a sensor anomaly occurs (- - - - displayed).
Setting Options
Descriptions
Specify by
example
Enter two known conversion points (up to ten digits each).
Specify by A/B
Enter the scaling coefficients (A and B, up to ten digits each).
Scaled units
• Select the
[SI Prefix]
.
(
[p]
=1E-12,
[n]
=1E-9,
[
μ
]
=1E-6,
[m]
=1E-3, blank =1E0,
[k]
=1E3,
[M]
=1E6,
[G]
=1E9,
[T]
=1E12)
• Enter the
[Char. String]
to identify the scaled units.
(Up to five characters, except \, /, :, *, ?, ", <, >, and |.)
Display digits
• Select
[Fixed decimal point]
and specify the
[Decimal digits]
to be dis-
played to the right of the decimal point. Valid settings are 0 to 3.
(Examples: selecting 0 displays values in the form 0000, and selecting 3 dis-
plays values in the form 0.000)
• When
[Fixed decimal point]
is not selected, values are displayed as four dig-
its (0.000 to
±
9999) with automatic decimal positioning.
Setting
confirmation
Confirm that scaling is performed properly. Enter any numerical value as raw
data, and click the
[Calc]
button to display the scaled result.
Upper and lower thresholds
Enter numerical values between -9999 and 9999 (up to six digits).
When scaling is enabled, enter these values as scaled results.
Enable alarm judgment
Select this check box to enable the alarm.
HIOKI LR5011B980-04
Summary of Contents for LR5011
