6.1 Displaying and Changing Collector System Settings
59
3
6
Chapt
e
r 6 Collect
or Sy
stem Sett
ings
You can set the time of the clock displayed on the collector.
Clock Setting
1
Show the top display of the collector.
(To return to the top display from another dis-
play, select
[Back]
or
[Cancel]
.)
2
Move the cursor to
[Unit Settings]
, and
then press the
button.
3
Move the cursor to
[Clock Setting]
, and
then press the
button.
(Press the
F3
button to return to the top dis-
play.)
4
Move the cursor to the digit you want to
change, and then use the
F1
or
F2
button
to change the number.
(To return to the previous display, press the
F3
button.)
5
Press the
button.
The time of the clock changes to the set time,
and the previous display reappears.
3
4
1
2
• If the time of the clock is not correct, the wrong time will be mistakenly
set on the logger and the time information for the collected data or SD
memory card files will not be correct, resulting in undesirable conse-
quences. Verify the clock display and set the correct time before using
the collector.
• If the clock setting is significantly different from the actual time when
the power is turned off and then back on again after the clock has
been set, the life of the clock backup battery is over. The battery
needs to be replaced so contact the place of purchase (dealer) or your
nearest Hioki sales office.
See:
Summary of Contents for LR5092
