7.2 Setting the Collector from the LR5000 Utility Program
80
Alarm Thresholds (set as needed)
Set the upper and lower alarm threshold values.
When a measurement is outside of the specified area, the
[AL]
(alarm) indicator is
displayed on the logger.
Click the
[Save]
button to save your settings.
(The display returns to the Logger Settings screen.)
Note: If you click the
[Cancel]
button without saving the settings, the display still returns to the
Logger Settings screen.
Note: Alarm judgment is performed at every recording interval during instantaneous recording,
and once per second during statistical recording.
Note: Alarm judgment is performed using measurement values with a larger number of digits
than the values (4 digits) indicated in the Data Logger's display.
Note: The
[AL]
indicator appears when the measured value is out of range (OF/UF dis-
played), and when a sensor anomaly occurs (- - - - displayed).
Upper and lower thresholds
Enter numerical values between -9999 and 9999 (up to six digits).
When scaling is enabled, enter these values as scaled results.
Enable alarm judgment function
Select this check box to enable the alarm.
Summary of Contents for LR5092
