3.3 Sending Measurement Condition Settings to Logger
26
Connect a logger to the collector, and then send the measurement conditions to the
logger.
Required Items: Logger to which you want to send the settings
3.3
Sending Measurement Condition Settings to
Logger
1
Show the top display of the collector.
(To return to the top display from another dis-
play, select
[Back]
or
[Cancel]
.)
2
Move the cursor to
[Logger Operation]
,
and then press the
button.
3
Move the cursor to
[Send/Receive]
, and
then press the
button.
(To return to the previous display, press the
F3
button.)
4
Place the logger and collector so that their
IR ports are aligned.
5
Move the cursor to
[To Logger]
, and then
press the
button.
(To return to the previous display, press the
F3
button.)
6
Press the
button (or
F2
button).
The settings are sent, and the previous display
reappears.
When you want to cancel the operation:
Press the
F1
button before the operation has
been performed to return to the previous dis-
play. Press the
F3
button to return to the top
display.
3
4
5
6
1
2
Summary of Contents for LR5092
