- 8 -
Operating Procedure
1. Fasten the
stand base
to the work bench securely, employing all three holes provided so that it will
withstand the torque delivered by the tool.
2. Pass the
slide arm
through the
shockless holder
and adjust the desired height of the arm on the stanchion
by loosening the
wing screw
and moving the
collar
. Re-tighten the wing screw.
Caution: Vibration may loosen the wing screw. Please check it periodically.
3. Check to see the point of the bit fits the type of screw to be turned. Neglecting this check can result in
damage to screw heads.
4. Attach the bit to the driver by pushing the
joint shaft collar
into the body. Check that bit is firmly
attached.
5. Connect the
5-core driver cord
to the CLT-80
Power Pack
. Then connect
the power cord to an AC outlet. Turn the power switch of Power Pack on and
check that the power lamp lights.
6. Use the torque adjustment nut to make the desired output torque level scale
setting. Note that this setting should be taken as an approximate value.
Make the setting by loosening the
adjustment nut stopper
and adjusting
the
torque adjustment nut
. The figure at the right shows the torque scale.
When the setting has been made, re-tighten the torque adjustment nut stopper
securely.
7. Next, try tightening one screw as a test. Set the
power switch
to the forward
(FOR) position and turn the screw by lightly applying the point of the bit to
the head of the screw. When the screw is tightened, remove the bit from the
screw head.
8. Using a Hios torque meter HDP Series*, loosen the screw, measuring the amount of torque. If the screw
wasn't tight enough, increase the driver's torque setting, or if not tight enough, decrease the torque setting.
Use this procedure to find the right torque setting for the fastening job.
9. To loosen a screw, set the
power switch
to the reverse (REV) position. The tightest screw can be loosened
by tapping the bit to the screw head a number of times.
Caution: When switching between forward and reverse drive always stop the operation of the motor by
setting the power switch to the middle position and waiting until rotation stops completely before
proceeding to the opposite drive setting.
* We recommend Hios torque meters for use in measuring tightening torque of screws and making
driver torque settings.
● Use the Hios HDP torque meter series for measurement of loosening and tightening torque of the
fastened screw.
● The HP series of torque meters can be used for checking torque settings of screwdrivers, torque
drivers or torque wrenches.
These instruments are displayed on the Hios home page:
www.hios.com
The scale indicates
output torque.
N
•
m
