■
I/O
35
/
52
■ Output status signals
OUT0 (Start OUT)
The status of the screw tightening operation is indicated.
The indicator lights up while the screw tightening operation is being performed.
OUT1 (Finish OUT)
The status of the screw tightening operation is indicated.
The indicator lights up for 100 ms after the screw tightening operation is complete.
OUT2 (FOR/REV OUT)
The current clockwise/counterclockwise setting is output.
OUT3 (Busy OUT)
The current operation status is output.
ON is output when shaft is in operation, and OFF is output when the shaft is stopped.
OUT4 (Error 1 OUT)
Output is performed when an SV-NET driver error occurs.
OUT5 (Error 2 OUT)
Output is performed when an operation error occurs.
OUT6 (Error 4 OUT)
Output is performed when an SV-NET controller error occurs.
OUT7 (Error 8 OUT)
Output is performed only when operation error with NG torque judgment occurs.
OUT10 (Torque judgment OK OUT)
Output is performed only when torque judgment is OK after operation is complete.
Summary of Contents for DCD-40L
