Hipo INKJET plotter manual
28
⑺
press
or
to adjust the paper to move forward or
backward, and install the paper feeding balance beam into the chase.
There are magnetic cores at both end of the balance beam, please do not
bump them into anything.
⑻
press the plastic paperweight sheet on both sides of the paper to
avoid imbalance.
(2) Printing steps
Run Hpgl2, there will be an interface of Figure 5-1, open the file (if
it is the first time you use it, you should set related parameters. There is a
corresponding setting table when it goes out of the factory ), and click
“plot”.
(3) Paper cutting steps
⑴
remove the paper collecting balance beam
⑵
cut down the plotted graph.
(4) Paper collecting steps
⑴
grasp the left end of the paper-collecting axle and push it to the
right, lift it
，
and remove the axle.
⑵
roll the cut-down printing paper over the scroll (better with two
people); grab the paper scroll, and rotate it in a opposite direction of
collecting paper to get off the tape. Rotate and pull out the axle. And then
tear the extra tape and paper.
The above steps show the procedure from paper loading, printing,
trimming, and to collecting.
(5) Factors affecting the print accuracy
①
the type of the paper. This plotter employs paper that weighs
between 30g to 120g. but when you change a different type of paper, please
readjust Length correction parameter.
②
when loading paper to the paper-collecting axle, please make
sure that the tenseness of the paper is consistent; both ends of the paper scroll
are smooth on the surface.
③
the quality of the paper scroll. Including the planeness of the
paper.
