11
Version: 2016-UK-2
Charging/batteries
Important!
The Winlet 350TH contains batteries with battery acid. Exercise great care with any leaked
acid. Normally, acid can only leak if the machine overturns. If any acid comes into contact with skin or eyes,
flush with plenty of water, and seek medical advice if required.
General
•
Never charge the Winlet 350TH if damage is evident on the battery charger connection cable. This
could be fatal!
•
Charging must always be done at the designated site, which must be dry and well-ventilated. At this
site, there must be no sparks from angle grinders, open flames or smoking, for example.
•
Do not start charging the batteries immediately after use. Allow the batteries to cool first.
•
Batteries stored for a prolonged period must have a maintenance charge (be fully charged), to avoid
damage to the batteries.
Charging
•
Always charge after use.
•
Turn the machine off with the ignition key/at the off-button.
•
Connect an earthed plug with voltage 230 V (110 V). Charging time is approximately 8 hours, if
the batteries are completely flat.
Service/maintenance
General
The Winlet 350TH is designed to cope with the demands and the environment extant at a construction site,
but its service life and safety can be reduced considerably if the stated service/maintenance items are not
complied with.
All mechanical joints must be checked at regular intervals to ensure that no components have worked loose.
In general, special attention is required after the initial hours of operation when the machine is brand-new,
as well as after the machine has been taken apart/any repairs.
Servicing by specialist personnel
As a minimum requirement, a full overhaul must be carried out by specialist personnel every 12 calendar
months. Contact GMV A/S for further information.
Cleaning
Clean the machine regularly with a damp sponge, brush or vacuum cleaner.
Important!
Do not wash the machine with running water, as this could ruin the truck components.