If you aren’t getting these responses, or the responses are reversed (it says “left” when
you move the sticks “right,“ forward” when you move the sticks “back,” or the values
between left and right are disproportionate to each other) check your transmitter’s manual
to troubleshoot your channels or invert your signals on your transmitter. The instruction
manual for your transmitter should tell you how to do that.
When all signals are correct, press the “Back” button to return main menu, and unplug your
battery.
Testing Your Signal
Estimated time to complete: 5 minutes
Turn on your transmitter and plug in your battery. You’ll hear a few beeps, and the Control
Board and your receiver will power up.
Now, let’s make sure your Control Board is getting signal from your transmitter.
Plug in your programmer if it isn’t already plugged in and press the rightmost key on your
Programmer to enter the “Menu.” Use the “Down” button to scroll to “Receiver Test,” and hit
the rightmost “Enter” key. You’ll see values from the inputs of your receiver. Move the sticks
on your transmitter and you should see those values change.
Moving your right stick up and down should change the value for “Elevator,” while moving
it left and right should change “Aileron.” Moving the left stick up and down should change
“Throttle,” and left and right should change “Rudder.”
