15
6
受信機とジャイロの取付
Receiver and gyro installation
7
ウォッシュアウトの組立
Washout assembly
Brg. ø4Xø8X3FZZ ................... 4
ø1.5 E
リング
.............................. 4
ø1.5 E-ring
M2X3SS ................................... 2
M3X22CS ................................. 1
M3X15CS ................................. 1
カラー
3X4X8.5F ....................... 2
Collar 3X4X8.5F
溝付き平行ピン
ø2X11.8 ........... 2
Grooved parallel pin ø2X11.8
注
意
Caution
注
意
Caution
注
意
Caution
ジャイロセンサー部には取付方向があります。
ジャイロの取扱説明書に従って取り付けてください。
Gyro sensor components should be installed as
per the directions according to the manufacture
of your gyro.
Be sure to check the gyro's directions for proper
operation and set up.
テープを貼り付ける前に、貼り付け部分の汚れなどを十
分に拭き取ってください。
Before adhering double sided tape to any
mounting surface, clean the area thoroughly
with alcohol or similar cleaning solution.
ウォッシュアウトコントロールアーム
の向きに注意してください。
Note washout control arm
orientation.
バッテリー、
ESC
の搭載位置によって
調整してください。
Adjust depending on battery/ESC
mounting position.
工場組立済
Pre-assembled
Brg. ø4Xø8X3FZZ
SSL
ウォッシュアウトコントロールアーム
SSL washout control arm
ø1.5 E
リング
ø1.5 E-ring
M2X3SS
M3X22CS
※割りのある方に使用
* Apply the bolt on the slit
side of the radius block.
M3X15CS
※割りのない方に使用
* Apply the bolt on the plain-
surface side of the radius block.
カラー
3X4X8.5F
Collar 3X4X8.5F
SSL
ウォッシュアウト
コントロールアーム
SSL washout control arm
ラジアスブロック
Radius block
ラジアスアーム
P=25
Radius arm P=25
溝付き平行ピン
ø2X11.8
Grooved parallel pin ø2X11.8
工場組立済
Pre-assembled
仮止め
Temporarily set
12
ローターヘッドの取付時に本締め、ロックタイト
固定を行います。
Securely tighten the CS and fix with thread locker
during 12 rotor head installation.