19
11
メインギヤの取付
Main gear installation
FW ø12Xø18X0.2T ................... 1
M2.6X6
皿
................................. 4
Countersunk screw
カラー
3.5X5X5.1 ...................... 2
Collar 3.5X5X5.1
M4X4SS .................................... 4
M3.5X10CS .............................. 2
M3X12TS .................................. 4
M2.6X6
皿
Countersunk screw
オートロ駆動軸
Auto-rotation drive shaft
切欠のある方に
M3.5
用の穴が
空いています。
The hole for the M3.5X10CS is
on the side with a notch.
Brg. ø12Xø21X5ZZ
Brg. ø12X16L
ワンウェイ
Bearing ø12X16L one-way
刻印が上にな
ります。
Point the side
with the punch
mark upwards.
オートロケース
Auto-rotation case
M3.5X10CS
M3.5X10CS
M4X4SS
カラー
3.5X5X5.1
Collar 3.5X5X5.1
セカンドギヤ
97T
Second gear 97T
EX
セカンドギヤハウジング
EX second gear housing
FW ø12Xø18X0.2T
C ø12Xø22X2.5T
メインギヤ
103T
Main gear 103T
M3X12TS
マストロック
Mast lock
メインマスト
P=181
Main mast P=181
工場組立済
Pre-assembled
注
意
Caution
注
意
Caution
メインマスト
Main mast
181mm
の穴を使用して
ください。
Use the holes positioned
at 181mm.
18
1m
m
18
6m
m
注:マストが上下にあそびがない事。
Note: Make sure mast assembly has no end play.
メインマストをいっぱい引っぱり上げ、マストロックを通し
M4X4SS
を締付けます。
Pull the main mast up through the mast lock and
fasten with M4X4SS.
マストロックをいっぱい
下げる。
Completely lower the
mast lock.
メインマストを引っ
ぱり上げる。
Raise the main mast.
マストロック
Mast lock
カウンターギアとセカンドギアの
バックラッシュの調整
Counter gear and second gear
backlash adjustment
ビニール袋を
1cmX5cm
に切ってセカン
ドギアとカウンターギアの間に差し込み、
カウンターギアを固定してから最後にセ
カンドギアを回してビニール片を引き抜
いてください。
Cut plastic bag about 1 cm X 5 cm. Put
the plastic piece between counter gear
and second gear.
Fix counter gear and turn second gear to
remove plastic piece.
ギヤのナメ防止と潤滑性の向上のため、必ず
メインギヤ、セカンドギヤにシリコンスプレー
をさしてください。
In order to prevent gears from slipping
and improve lubrication, always spray
the main gear and second gear with
silicone spray.
ポイント
Point