HIROSE ELECTRIC CO.,LTD.
ETAD-T0652-00
1
4
/6
FORM HC0011-9-2
△
0
(4) Spread out the outer conductor with the dedicated tool, insert the outer ferrule, and return the outer
conductor to cover the outer ferrule.
Note: 1.
Be careful not to unweave the outer conductor when spreading out the outer conductor.
Do not spread out the copper foil or aluminum foil. Make sure that the copper
foil and aluminum foil are inside the outer ferrule.
Note
:
2.
Check that the direction of the outer ferrule is correct as shown in the illustration below.
Coincide the slit of the outer ferrule with the protruding part of the center contact and
insert the outer ferrule.
Note:
3.
Insert the outer ferrule until the step of the outer ferrule comes to the edge of the sheath.
Note:
4.
Pay attention not to pull the outer conductor into the sheath when inserting the outer
ferrule.
(5) Use the dedicated jig and insert the contact ferrule from the mating side of the center contact until the
contact ferrule comes in contact with the dielectric material.
Note: 1.
Check that the direction of the contact ferrule is correct as shown in the illustration below.
Coincide the slit of contact ferrule with the protruding part of the center contact and insert
the contact ferrule.
Note: 2. Pay attention not to deform the crimped contact.
0.2±
0.2
1
Jul.1.2022 Copyright 2022 HIROSE ELECTRIC CO., LTD. All Rights Reserved.