HIROSE ELECTRIC CO.,LTD.
ETAD-T0652-00
1
6
/6
FORM HC0011-9-2
△
0
1
(8)
Use the dedicated jig and crimp the outer contact.
Note: 1.
Refer to “The Crimp Condition Table” for the crimp height.
Note: 2.
Refer to “The Crimp Quality Standard Sheet” for the crimp work standards.
Note: 3. Confirm that the insulator is fixed by the lance of the outer contact.
(9)
Insert the outer contact into the housing.
Note: 1. Coincide the protruding part of the outer contact with the groove of the housing and insert
the outer contact.
Note: 2. Insert the outer contact until the position of the outer contact is fixed by the lance of the
housing.
(10)
Harness work completed
0.4
Jul.1.2022 Copyright 2022 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
