Access to the device
3.2
User management
63
UM Config GRS
Release
8.0
09/2019
3.2.5
Setting up a new user account
Allocate a separate user account to each user that accesses the device management. In this way
you can specifically control the authorizations for the access.
In the following example, we will set up the user account for a
USER
user with the role
operator
.
Users with the
operator
role are authorized to monitor and configure the device - with the
exception of security-related settings.
Perform the following steps:
Create a new user account.
Note:
When you are setting up a new user account in the Command Line Interface, remember to
Open the
Device Security > User Management
dialog.
Click the button.
The dialog displays the
Create
window.
Enter the name in the
User name
field.
In this example, we give the user account the name
USER
.
Click the
Ok
button.
To obtain a higher level of complexity for the password, mark the checkbox in the
Policy
check
column.
Before saving it, the device checks the password according to the policy specified in the
Password policy
frame.
In the
Password
field, enter a password of at least 6 characters.
Up to 64 alphanumeric characters are allowed.
The device differentiates between upper and lower case.
The minimum length of the password is specified in the
Configuration
frame. The device
constantly checks the minimum length of the password.
In the
Role
column, select the user role.
In this example, we select the value
operator
.
To activate the user account, mark the checkbox in the
Active
column.
To save the changes temporarily, click the button.
The dialog displays the user accounts that are set up.
enable
Change to the Privileged EXEC mode.
configure
Change to the Configuration mode.
users add USER
Creates the
USER
user account.
users password-policy-check USER
enable
Activates the checking of the password for the
USER
user account based on the specified policy. In this
way, you obtain a higher level of complexity for the
password.
users password USER SECRET
Specifies the password
USER
for the
SECRET
user
account. Enter at least 6 characters.
users access-role USER operator
Assign the user role
operator
to the user account
USER
.
users enable USER
Activates the
USER
user account.
show users
Displays the user accounts that are set up.
save
Save the settings in the non-volatile memory (
nvm
)
in the “selected” configuration profile.
Summary of Contents for GREYHOUND GRS1020
