Hirschmann PAT TRS 05 / PATB3, Installation And Setup Manual

Installation / Setup Manual  TRS 05 / PATB3 

© Hirschmann Rev. -03/09/2006 

190203_- 

3.2 

UNINSTALL SENSOR / TRANSMITTER 

If a sensor is setup on the channel the LED will be on, press and hold the ID button (9-15 seconds) 
through the Install Sensor mode (blinking LEDs1-2) until the correct 1-2 LED is solid. When the correct 
LED is solid, channel to be uninstalled, release the ID button. The sensor for the selected 
channel/LED 1-2 will be uninstalled and the system will be in normal operating mode. 
 
As the ID button is held (9-15 seconds) through the Install Sensor mode (blinking LEDs1-2) and 
released at the solid LED, the following actions will occur: 
 
Green LED 1 solid: Uninstall sensor 1. 
Green LED 2 solid: Uninstall sensor 2. 
 
This is a basic overview table of the menu selections fro the TRS 05. Press and hold ID button, 
release the button at the desired indication (or the number seconds) defined in the following table.  
 
NOTE: If an incorrect menu is activated or the button is released accidentally, simply cycle the power 
and start over.  
 

Menu Selection Release ID Button 

Indication 

Indication 
Starts 
(Sec) 

Indication 
Ends 
(Sec) 

Install/setup sensor on channel 1 

blinking green LED 1 

3 

6 

Install/setup sensor on channel 2 

blinking green LED 2 

6 

9 

Uninstall a sensor on channel 1 

solid LED 1 

9 

12 

Uninstall a sensor on channel 2 

solid LED 2 

12 

15 

Exit/No action 

LEDs off no action 

16