Hirschmann PAT TRS 05 / PATB3, Installation And Setup Manual

Installation 

© Hirschmann Rev. -03/09/2006 

190203_- 

3

Model: PAT TRS 05

This device complies with Part 15 of the FCC rules. 
Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, 
and (2) this device must accept interference that may 
cause undesired operation.

ALARM

POWER

SENSOR LOW BATTERY

SENSOR ON LINE

1.2 RECEIVER 

MOUNTING 

 
The receiver module should be mounted so the operator can view the LEDs and setup the system for 
operation. The location of the receiver should be in direct line of site of the transmitter and blocked by 
as little metal as possible between the transmitter and receiver. However, in some cases the receiver 
has been installed surrounded by metal and worked well. The location needs to be tested before 
mounting the hardware. If the signal is lost, the box/receiver indicates a link error. 
 
Securely attach the receiver onto a solid surface using the mounting holes. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

1.3 ANTENNA 

MOUNTING 

 
The TRS 05 receiver will mount in the same place as the A2B receiver. Attach the 13ft long antenna 
base and whip to the TRS 05; and mount the magnetic antenna parallel to the ground, as shown  
 

below.