18
Quick Problem-Solving Tips
When you experience an issue with your Laser Cinema, turn it off and on again. If this does not resolve the problem, then refer to the
tips below.
When I turn on my Laser Cinema, there is a delay for a few seconds before the picture appears. Is this normal?
Yes, this is normal. The Laser Cinema is initializing and searching for previous setting information.
No sound or picture
1. Check if the power cord is plugged into a powered AC outlet.
2. Press the
Power button on the remote control to activate the unit from 'Standby' mode.
Maintenance
•
Do not touch this device when it is running or just turned off because it may be hot.
•
Do not wipe this device with oil because it may deteriorate the exterior or damage the paint. Contact with rubber or ethylene
products for a long time may cause stains on this device.
•
If the outside of the Laser Cinema is dirty, turn off the Laser Cinema and wipe with a damped soft cloth.
•
Do not touch the lens with your hands.
•
Do not touch or wipe the lens with ordinary cleaning cloth. Use a dust blower to remove the dust on the lens. Grease, dirt and
fingerprints should be cleaned carefully by the professional by using optical cleaning cloth, lens wiping paper or professional
cleaning solutions to avoid destroying the optical filming and affecting the image quality.
•
To turn off this device, press the Power button on the remote control. Do not cut off the power directly when the device is working.
Summary of Contents for 120L9G
Page 26: ...ES L212208 1 ...
