8
.
Place the lower door on a smooth
surface with its paneI upwards.Loose
screw
②
and part
①
,then lnstall them to
the left side and tighten securely.
9.Change screw hole covers on middle
cover plate from left to right(as shown in
figure below).
10.Lay the refrigerator on soft foam
packaging or similar materiaI.Remove
both adjustable bottom feet parts,and
the lower hinge part by unscrewing
the special flange self-tapping screws.
11
5.Remove the upper door from the middle
hinge by carefully lifting the door straight up.
Note:
When removing the door,watch
for washer(s) between the center hinge
and the bottom of the upper door that
may stick to the door.Do not lose.
6.Place the upper door on a smooth
surface with its panel upwards.Loose
screw
②
and part
①
,then Install them to
the left side and tighten securely.
7.Unscrew the two special flange self-
tapping screws which are used for fixing
the middIe hinge part,then remove the
middle hinge part that hold the Iower
door in place.
Note
:
When removing the door, watch for
washer(s) between the Iower hinge and
the bottom of the lower door that may
stick to the door.Do not lose.
①
Stop block
②
Self-tapping screw
①
Stop block
②
Self-tapping screw
screw hole covers
screw hole covers
①
Lower hinge part(right)
②
Adjustable bottom feet part
SeIf-tapping screws
③
