Hisense 50A7G, Quick Setup Manual

12

Remote Control

  Installing Batteries in the Remote Control

 NOTES

Product image is only for reference, actual product may vary in appearance.
Dispose of your batteries in a designated disposal area. Do not throw the batteries into fire.
Do not mix battery types or combine used batteries with new ones.
Remove depleted batteries immediately to prevent battery acid from leaking into 

the battery compartment.
If you do not intend to use the remote control for a long time, remove the batteries.
Batteries should not be exposed to excessive heat, such as sunshine, heat 

registers, or fire.
Battery chemicals can cause a rash. If the batteries leak, clean the battery 

compartment with a cloth. If chemicals touch your skin, wash immediately.

1. Slide the back cover to open the battery compartment 

of the remote control.

2. Insert two AAA size batteries. Make sure to match 

the (+) and ( - ) ends of the batteries with the (+) 

and ( - ) ends indicated in the battery compartment.

3. Close the battery compartment with the cover. 

NOTE:

 Check information according to the actual remote control in the accessory bag.

  Pairing the Remote Control (only for Bluetooth remote control)

Pair the remote to the TV after you power it on. Keep the remote control within 3 

metres from the TV. Press any button (except power and mic button) to pair.

 NOTES

In special cases, press and hold [   ] button to pair.
If an unknown error occurred with the remote, then it could have been caused by 

interference. Try to remove what's causing the interference and pair it again.

If an unknown error occurred in the remote control while the battery power is 

normal, you can take out the batteries, press any key for 1~2 seconds, and insert 

them back. Then the remote control will work normally.

The remote cannot be paired to the TV while the TV is in standby mode.