3
Installing the Stand or Wall Mount Bracket
1. Remove buckles on both sides of the carton box
,
take out the upper box and
cushion, place cushions parallel with the ground with their grooves face-up, the
distance between two cushions should be less than that of the base holes.
2. Two people from each side hold the top of the television using one hand, support
its bottom or hold small handles using the other hand to lift the television together,
move the television vertically to the grooves in the upper cushions.
Big handles
Small handles
Upper cushions
3. One person holds the television from the front side, the other person takes out 4
screws(M5×16) to install the stand in the following steps: take out the cable clamp
in the stand, secure the stand with screws and then restore the cable clamp to its
original place. After installation, remove the handles and move the television to
designated spot.
Note: According to practical needs, both A-type(L1R1) span and B-type(L2R2) span
can be selected when the base stands are installed as shown in the figure.
But please note that A-type and B-type cannot be mixed when installing the stand.
For
85"
Follow the illustrations and textual instructions below to complete the installation steps:
Two people and above are required.
B L2R2
Cable clamp
Stand
Screws
A L1R1
Stand
Cable clamp
Screws
Summary of Contents for 55U8G
Page 1: ...Bar code ...
Page 3: ...A Declaration ...
