In case of transportation after unpacking, protect the unit with the splints or cloth.
Do not put any foreign material into the outdoor unit and check to ensure that none exists in the
outdoor unit before the installation and test run. Otherwise, a fire or failure, etc. may occur.
NOTE
When using forklift, do not insert forks into
the holes on the unit side. The unit may be
damaged.
Do not apply excessive force to the square holes
with forks or other materials. The bottom of the
unit may be deformed.
* Do not push the bottom base by fork.
* Do not use roller.
8.2 Hanging Method
When hanging the unit, ensure a balance of the unit, check safety and lift up smoothly.
(1) Do not remove any packing materials.
(2) Hang the unit under packing condition with two (2) wire ropes, as shown in the following figure.
(3) Hang the unit without wooden base with two (2) wire ropes, as shown in the following figure.
Forks
The holes on
the unit side
Do not apply excessive force.
(Both Sides)
Wooden Base
Do not apply any force
to thise place.
(Both Sides)
Apply rope on the splints or
corrugated paper of more than
15mm thickness.
Apply rope through
the square holes.
Do not remove
corrugated paper frame
and plastic bands.
Wire Rope
Corrugated Paper Frame
Angle of wire rope
is more than 60
o
.
Wire Rope
Wire Rope
Square
Hole
Square
Hole
Rope Position
INCORRECT
CORRECT
Do not apply any force
to thise place.
(Both Sides)
Apply rope on the splints or
corrugated paper of more than
15mm thickness.
Apply rope through
the square holes.
Do not remove
corrugated paper frame
and plastic bands.
Wire Rope
Corrugated Paper Frame
Angle of wire rope
is more than 60
o
.
v
Handling of Outdoor Unit
94
