Install Support Bracket
MARK
MARK
"
Long Bolt
and Locknut
(
4
)
1
⁄
2
2. Attach sill angle brackets to support brackets at
marked positions with flat head bolts and nuts.
Hand tighten only at this point.
RIGHT
LEFT
Angle Brackets
"
Long Flat Head
Bolt and Locknut
3
⁄
4
"
Long Bolt
and Locknut
1
⁄
2
4.
Adjust height of sill angle bracket so that bracket
rests securely on edge of sill, and so that cabinet
has the correct
downward tilt for proper water
drainage
.
Tighten
nuts
securely.
3
°
Side
Louvers
Window
Sash
Sill
Angle
Bracket
Window
Sill
t
abou
3
°
8
1/4"screws
1. Hold each support bracket flush against outside
of sill and tight to bottom of cabinet. Mark
brackets
at top level of sill. Mark cabinet bottom
at distance
of sill width. Remove support brackets.
3. Insert 1/2" long bolts through appropriate holes in
cabinet bottom given the sill width distance.
Thread
the bolts into the
slots
of
the
support
brackets
.
Tighten
lock
washer
nuts
onto
bolts
.
5
.
Place the frame lock between the base and the
cabinet
sill with 1/4" (6,5
mm
) screw as shown.
NOTE
:
This lock frame
is only provided for 12K BTU model.
Attach The Top Rail To Window
1. Close window behind top angle rail.
2. Attach the top angle rail to window frame: Use a drill bit to drill one hole through the hole in the middle of top
angle rail into the window frame,and drive one 3/4" locking screw through the hole in the middle of top angle
rail into the window frame as shown.
Summary of Contents for AW-12DR3RYFU20
Page 2: ......
