Hisense H5507, User Manual

7

Connecting your TV to a Wired or Wireless Network

Wireless Adapter 

built-in the TV set

LAN Cable

Wireless Router

The LAN Port on the Wall

Connecting Your TV to a Wired or Wireless Network

Connecting to a Wired (Ethernet) Network

You have the option to connect your TV to a wireless or wired network to access the Internet. 

You can attach your TV to your LAN in one of the three following ways:

Option 1.

• 

You can attach your TV to your LAN by connecting the LAN port on the back of your TV to an external modem using a Cat 5 

LAN cable. See the illustration below. 

Our built-in wireless LAN adapter supports the IEEE 802.11 b/g/n communication protocols and we recommend that 

you use an IEEE 802.11n router. When you play a video over an IEEEE 802.11 b/g connection, the video may not play 

smoothly.

•  You must use the Hisense built-in Wireless LAN Adapter to use a wireless network because the set does not 

support an external USB network adapter.

•  To use a wireless network, your TV must be connected to a wireless IP sharer. If the wireless IP sharer supports 

Dynamic Host Configuration Protocol (DHCP), your TV can use a DHCP or static IP address to connect to the 

wireless network.

•  Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless IP 

sharer is currently being used by another device nearby, this will result in interference and communication failure.

•  If you apply a security system other than the systems listed below, it will not work with the TV.

•  If Pure High-throughput (Greenfield) 802.11N mode is selected and the Encryption type is set to WEP, TKIP 

or TKIP-AES (WPS2 Mixed) for your Access Point (AP), then the Hisense TV will not support a connection in 

compliance with these Wi-Fi certification specifications.

•  If your access point (AP) supports Wi-Fi Protected Setup (WPS), you can connect to the network via Push Button 

Configuration (PBC) or PIN (Personal Identification Number). WPS will automatically configure the SSID 

       and WPA key in either mode.

Figure 8

. Connect the TV to a wireless network

Figure 9

. Connect a LAN port on the TV to an external modem

Connecting to a Wireless Network

(not included)

NOTES

External Modem

(ADSL / VDSL / Cable TV) 

The Modem Port on the Wall

LAN Port on TV

Ethernet Cable 

Modem Cable 

LAN