Shortcut Functions of the Remote Control
Battery Replacement Procedure
1.
Put the remote control with its back facing up and open the battery box.
2.
Install two 1.5 V AAA alkaline batteries. Ensure that the positive (+) and negative (–) electrodes
of the batteries match those of the battery box.
3.
Push the battery box cover upwards until it fits into the body of the remote control.
Precautions on Remote Control Operations
1.
If the remote control works abnormally or unstably or cannot control the LCD monitor, check
whether the LCD monitor is started, whether the positive and negative electrodes of the batteries
are reversely installed, whether the battery energy is depleted, and whether special fluorescent or
neon gas signals exist in the surrounding area.
2.
Take out the batteries if the remote control will not be used for a long time or the battery energy is
depleted. Handle scrapped batteries properly to avoid environmental pollution.
3.
CAUTION: Use of an incorrect battery model may result in explosion. Be sure to handle used
batteries based on instructions.
Valid Range of Remote Control Operations
1.
Distance: The valid range is within 8 meters right ahead of the front of the remote control receive
window.
2.
Angle: With the remote control receive window as the culmination and in a distance of 6 meters
from the window, the control angle is not inferior to ±30° in the horizontal direction and not
inferior to ±15° in the vertical direction.
3.
The remote control may experience reduced sensitivity after being used for a long time due to
infrared interference. It is recommended that you bring up the touch menu by using the five-point
touch mode.
Shortcut Functions of the Remote Control
1.
Settings
button: Press this button to go to the
Settings
screen, which provides the
Image
,
General
,
Internet
,
Sound
, and
About
menus. You can set the LCD monitor on the
Settings
screen.
2.
Menu
button
Press this button in the USB channel to go to the menu. This button is disabled in other channels.
3.
Mute
button
Press this button to mute the LCD monitor. Press it again to unmute it.
11
