Installation
Instructions on Removing and Installing the Rear Housing Cover
Removal procedure
1)
Open the snap-fit joint marked with
③
on the cover.
2)
Put your hand in the position marked with
④
and force open the snap-fit joint marked with
②
.
3)
Remove the cover.
Installation procedure
1)
Insert the part of the cover marked with
①
into the rear housing.
2)
Press tight the snap-fit joint marked with
②
on the cover.
3)
Press tight the snap-fit joint marked with
③
on the cover.
The following figure shows the rear housing with the cover correctly installed.
Hanging Arm Installation
Remove the base assembly to install the required hanging arm or base.
Follow the instructions in the User Guide when installing the hanging arm or base.
| Hisense Product User Guide | Installation | 8