Step-by-step installation guide
23
Blower Plate screw
Blower motor screw
Back of
Microwave
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet bottom.
• Drill the holes, following the instructions on the TO
CABINET TEMPLATE.
CAUTION : Wear safety goggles when
drilling holes in the cabinet bottom.
C 2.
USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
You need to drill holes for
the top support screws
and a hole large enough for the power cord to fit through.
BEFORE : Fan Blade
Openings Facing UP
Blower Motor
C 3.
ADAPTING BLOWER FOR RECIRCULATION
1.Remove and save screw that holds blower motor to microwave, Lift up the blower plate.
2.Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit.
3.
5. Replace the blower plate in the same position.
Rotate blower unit 90°.
Before Rotation
Afte
r
4. Place the blower unit back into the opening.
After Fan Blad
Openings Facing Front
Back of
Microwave
Back of
Microwave
Aft
e
r
Back of
Microwave
CAUTION:
Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
NOTE:
The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
