A
DANGER
To avoid the risks that are always present
when using an electric appliance, we
recommend that you pay attention to the
instructions about electricity below.
l . The appliance requires single phase
l 15V/60Hz power supply. It has a power cord
that has a 3-prong grounding plug that
minimizes the possibility of electrical shock. This
appliance must be grounded. Do not remove
the grounding prong or modify the power plug.
2. The unit should be plugged into a dedicated
electrical outlet that meets all current standards
and requirements. Do not plug anything else
into the same outlet and ensure the appliance is
the only thing plugged into the entire circuit. It
should have its own dedicated breaker.
Otherwise, this may overload the circuit and
cause a fire.
3. Do not modify the power plug. The power
plug must be accessible when the appliance is
installed.
4. The appliance should not be turned off with a
switch or other device.
5. Make sure that the plug is not squashed or
damaged. Otherwise, it may cause short circuit,
electric shock or overheat and even cause a fire.
6. Do not insert the power plug if the socket is
loose, there is a risk of electric shock or fire.
7. Switch off the appliance and disconnect it
from the main power before you clean or
move it.
8. Never unplug the appliance by pulling on the
electrical cord. Always grip the plug
firmly and pull straight out from the socket to
prevent damaging the power cord.
9. Do not operate the appliance without the
cover over the interior lighting.
l O. Any electrical component must be
replaced or repaired by a qualified electrician
or authorized service engineer. Only genuine
replacement parts should be used.
11. To avoid eye injury, do not look direct into
the LED light located in the refrigerator
compartment. If it is not functioning correctly,
consult a qualified, registered electrician or
replace it in accordance with the Cleaning
and Care chapter.
12. The refrigerant isobutene (R600a) is
contained within the refrigerant circuit of the
appliance. During transportation and
installation of the appliance, ensure that none
of the components of the refrigerant circuit
become damaged. The refrigerant (R600a) is
flammable.
13. Risk of child entrapment. Before you throw
away your old appliance:
Take off the doors
Leave the shelves in place so that children
may not easily climb inside.
A
CAUTION
l . Don't store products which contain
flammable propellants (e.g. spray cans) or
explosive substances in the appliances.
2. Avoid open flames (candles, lamps etc.)
and other sources of ignition.
3. Thoroughly ventilate the room in which the
appliance is situated.
4. Unpack and check through the appliance.
Should any damage be evident, dont plug in
the appliance but contact the shop immedi
ately from which you purchased it. Keep all
packing materials in this case.
5. We recommend that you wait for 4 hours
before connecting the appliance to allow the
refrigerant to flow back into the compressor.
4
