11
5. Unscrew the two special flange self-
tapping screws which are used for
fixing the middle hinge part, then
remove the middle hinge part that hold
the lower door in place.
NOTE:
When removing the door, watch
for washer(s) between the center hinge
and the upper of the lower door that
may stick to the door. Don't los
e
it.
7. Change screw and screw hole covers
on midde cover plate from left to right (as
shown in figure below).
screw hole covers
screw hole covers
8. Lay the refrigerator on soft foam
packaging or similar material. Remove
both adjustable bottom feet parts
①
,
then remove the lower hinge part
②
by
unscrewing the special flange self-
tapping screws
③
.
①
②
③
①
Adjustable
bottom
feet
part
②
Lower
hinge
part
(
right
)
③
Self-tapping screw
9.Remove part
①
from the lower
hinge part(right), loose out the lower
hinge pin, change it to the reverse
hole site, and then tighten into
position, then install part
①
on the
lower hinge pin.
6. Place the lower door on a smooth
surface with its panel upwards.
Loose screw
③
and take down part
①
and
part
②
, then Install door stopper-
left
④(
provided in the plastic bag) and
left part
②
and
screw
③
to
the
left
side
and tighten them securely.Keep part
①
①
②
③
①
Door stopper
②
Stop block
③
Self-tapping screw
④
④
Door stopper
-
left
①
①
②
③
①
Door stopper
②
Stop block
③
Self-tapping screw
④
④
Door stopper
-
left
with the appliance for future reference.
screw
screw
10. Change screw hole covers on lower
cover plate from left to right (as shown
in figure below).
screw hole cover
screw hole cover
Summary of Contents for RB372N4CC2
