The
refrigerant
and
risk
of
fire
Installing
your
new
appliance
Ventilation
of
appliance
●
●
●
●
●
●
●
●
●
●
●
75
100
100
Before using the appliance for the first
time, you should be informed of the
following tips.
In order to improve efficiency
of the cooling system and save
energy, it is necessary to maintain
good ventilation around the appliance
for the dissipation of heat. For this
reason, sufficient clear space should
be available around the refrigerator.
Suggest :It is advisable for there to be
at least 75mm of space from the back
to the wall, at least 100mm from its
top,at last 100mm from its side to the
wall and a clear space in front to allow
the doors to open 135°. As shown in
following diagrams.
Note:
This appliance performs well within
the climate class showed in the table
below.
in the refrigerant circuit. Check the
compressor label on the rear of the
appliance to see which refrigerant is
used for your appliance.
If the appliance contains iso-butane
( R 6 0 0 a ) r e f r i g e r a n t , w h i c h i s
environmentally friendly but flammable,
ensure that tubing of the refrigerant
c i r c u i t i s n o t d a m a g e d d u r i n g
transportation and installation to avoid
risk of fire caused by leaking
refrigerant.
Keep burning candles, lamps and
other items with naked flames and
sources of ignition away from the
appliance and ventilate the room
thoroughly to avoid the risk of fire and
eye injury should any leakage of
refrigerant (R600a) exist.
Do not store products which contain
flammable propellants (e.g. spray
cans) or explosive substances in the
appliance.
The room space must be at least 1m³
per 8g of refrigerant (R600a). The
amount of refrigerant in your appliance
is indicated on the rating plate inside.
Switch off the appliance and
disconnect it from the mains power
before you clean or move it.
Never unplug the appliance by pulling
on the electrical cord. Always grip the
plug firmly and pull straight out from
the socket to prevent damaging the
power cord.
Do not operate the appliance without
the light cover of interior lighting.
Any electrical component must be
replaced or repaired by a qualified
electrician or authorized service
engineer. Only genuine spares should
be used.
Do not use electrical appliances such
as ice cream makers inside the food
s t o r a g e c o m p a r t m e n t s o f t h e
appliance, unless they are approved
by the manufacturer.
Do not look direct into the LED light
located in the refrigerator compartment
with optical instruments to avoid eye
injuries. If it is not functioning correctly,
consult a qualified, registered
electrician or replace it in accordance
with the “cleaning and care” chapter.
The appliance contains a
small quantity of refrigerant
(R600a or R134a)
100
100
Hisense Refrigerator
4
755
1283
1004
