For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need
to be adjusted. You can adjust them
manually by hand or by using a suitable
tool.
To allow the doors to self-close, tilt the
top backwards by 0.4" - 0.6".
Leveling of appliance
In case your home access door is too
narrow for the refrigerator to pass
through, remove the refrigerator doors
and drawers. If you do not need to
remove the appliance doors, proceed
to ‘Installing Water Lines’ on page 8.
If you need to remove the doors,
continue below.
Door Removal
:
Adjustable
bottom feet
Front roller
Rear roller
0.4"~0.6"
Adjustable
bottom feet
Allen Wrench (5/32",4mm)
Philips Screwdriver
Wrench (5/16",8mm)
Tools you will need(Not provided)
1.With the door closed, remove the 3 screws
holding the top cover (A) with Philips (+)
screw driver, and then remove the top cover
with the entire-harness atached.
2.Remove the 3 screws (B) fixed on the hinges
with a wrench (5/16”, 8mm) and 1 ground
screw (C) attached to the hinge with Philips (+)
screw driver. Remove the upper left and right
door hinges(D).
6
Summary of Contents for RQ22N6ASD
Page 22: ......